Automation?

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

In this Discussion

Automation?
  • looking at the Inspector, then the Track View, it would make sense that there's some way to get Automation in there. Is it available yet, or can someone tell me how to do it?
  • Automations are applied on a pattern within the Ohm Studio. So:
     - create a pattern first (pen or arrow+cmd when zoomed out)
     - select it
     - open the inspector
     - select the parameter you want to add
     - zoom in the pattern (double click or cmd+scroll), you can see that a new automation point has been added
     - select it then use pen (or arrow+cmd) to create a new point of that parameter. 
     - zoom out (esc or cmd+scroll)
    Then you can loop automation like any other pattern.
    You can have notes + many automations curves in the same pattern.